Xerox Telecopier 7017 Technical Reference Manual page 5

6. Look upward into document output area
(between upper and lower scan covers).
LED array on A1 (video assembly) is off.
(Ignore the momentary flash.)
Y N
| Replace A2.
7. Approximately 15 seconds after terminal
powers up, following message appears:
LOAD ORIGINALS FACE DOWN IN INPUT TRAY
TIME
Y N
| Check document sensor (RAP 2.3.8);
replace A2, A10
8. Error Correct LED is off.
Y N
| Press Comm Mode key one time,
then go to next step.
9. Only one Original LED,
Resolution LED, and only one Comm
Mode LED are on.
Y N
| Replace A2, A6.
10. Control panel LEDs on
flashing).
Y N
| Replace A2, A6.
NOTE: If keys do not function properly at any
time during remainder of test, replace A2, A6.
11. Tone is heard when Stop key is pressed.
Y N
| Replace A2, A6, speaker.
Off-Line System Check
12. Run Auto Diagnostics.
a. Press Menu.
b. On the key pad, press 2 then 4.
c. Press Start. The display indicates:
24
Y N
| Perform
DATE
indicated. Go to Section 2. for the
Error Code List.
13. Printer operates without excessive motor
noise during the print operation.
Y N
| Check printer belt (RAP 2.3.11);
replace A2, print motor.
14.Printer completely feeds approximately
14 inches (35.5 cm) of recording paper
only one
out of the terminal.
Y N
| RAP 2.3.6; replace A2.
15. Recording paper is cut.
Y N
steady (not
| RAP
solenoid.
16. The diagnostic test pattern is acceptable
(compare to test pattern in Section 3).
Y N
| RAP 2.3.3
NOTE: If extended operation of printer is
desired, perform RAP 2.3.7 Paper Feed Test.
www.printcopy.info
DIAGNOSTICS
the operator action
2.3.6; replace A2, cutter
12/88
1-4
17. Set document guides for 8.5 inches (21.6
cm).
18. Place original (test pattern 82P151) into
the ADF face down.
indicates:
DIAL TELEPHONE NUMBER
PRESS [COPY] TO MAKE A COPY
Y N
| Check document sensor (RAP 2.3.8);
replace A2.
19. Press Copy, then press Start.
cycles only once as original is fed into
scanner.
Y N
| Replace A2, nudger solenoid.
20. Scanner motor noise
excessive noise).
Y N
| Replace A2; check scan input drive
belt (RAP 2.3.11); replace scan motor.
21. Original is fed through scanner.
Y N
| Replace video assembly, A2.
22. Recording paper is cut, and original feeds
out.
Y N
| Check scan position sensor (RAP
2.3.8), scan output drive belt (RAP
2.3.11); replace A2.
23. Original is unwrinkled.
Y N
| Check platen belt (RAP 2.3.11);
replace A2, scan motor.
Telecopier 7017 / 7017SF
The display
Nudger
is normal (no