Xerox Telecopier 7017 Technical Reference Manual page 15

2.2.5 OPXX Error Codes
Code Meaning
OP03 Invalid telephone number detected
*
during pulse dial (#, )
OP05 Store memory full detected.
OP06 Communication data memory empty
(Service mode only)
OP10 Job card not detected in job reserve
mode.
OP12 Unauthorized Job Card detected.
OP13 Start hole/information hole is too long.
OP14 Bottom interval is too short.
OP15 Hole interval is too long.
OP22 No document detected in ADF.
OP23 Document is sensed by scan position
sensor.
OP24 Misfeed in ADF.
OP25 Document is too long or jammed.
OP32 Recording paper is low or empty.
(Normal case)
OP32 Recording paper is low or empty.
(Special case)
OP36 Recording paper remained by the
jam sensor. (Normal case)
OP36 Recording paper remained by the
jam sensor. (Special case)
Telecopier 7017 / 7017SF
Display message
TELEPHONE NUMBER ENTERED INCORRECTLY
*
PLEASE REMOVE ANY # or -TRY AGAIN
MEMORY CAPACITY EXCEEDED-PLEASE DIVIDE
JOB AND RESEND
THERE IS NO INFORMATION AVAILABLE TO
REPORT
JOB CARD NOT DETECTED-PLEASE RELOAD JOB
IN INPUT TRAY
JOB CARD NUMBER DETECTED DOES NOT MATCH
NUMBER IN JOB MEMORY-PLEASE MATCH OP12
JOB CARD IS WORN-PLEASE REPLACE WITH NEW
JOB CARD
JOB CARD IS WORN-PLEASE REPLACE WITH NEW
JOB CARD
LONG ORIGINAL OR JAM DETECTED IN
SCANNER-PLEASE REFER TO MANUAL.
NO ORIGINALS DETECTED-PLEASE RELOAD
ORIGINALS AND TRY OPERATION AGAIN
ORIGINAL DETECTED IN SCANNER-PLEASE
REMOVE ORIGINAL FROM SCANNER
ORIGINALS OR JOB CARD DID NOT FEED
PLEASE CLEAN FEED BELT & TRY AGAIN
LONG ORIGINAL OR JAM DETECTED IN
SCANNER-PLEASE REFER TO MANUAL
RECORDING PAPER LOW-PLEASE REPLACE OP32
RECEIVED DOCUMENT IN MEMORY
RECORDING PAPER LOW-PLEASE REPLACE OP32
RECORDING JAM-CLEAR PAPER PATH
RECEIVED DOCUMENT IN MEMORY
RECORDING JAM-CLEAR PAPER PATH
8/88
2-5
www.printcopy.info
Corrective Action (after performing message)
Perform System Check
OP03
Perform System Check
OP05
Perform System Check
OP06
Perform System Check
Perform System Check
Perform System Check
OP13
Perform System Check
OP14
Perform System Check
OP15
Perform System Check
OP22
Check scan output drive belt (RAP 2.3.11),
OP23 scan position sensor (RAP 2.3.8); replace A2
Check scan input drive belt (RAP 2.3.11),
OP24 scan position sensor (RAP 2.3.8); replace A2
Perform System Check
OP25
Check low paper sensor (RAP 2.3.8);
Check low paper sensor (RAP 2.3.8);
Perform System Check
OP36
Check printer jam sensor (RAP 2.3.8),
OP36
OPXX Error Codes
replace A2
replace A2
replace A2