Prepare For System Checks; Off-Line System Check - Xerox Telecopier 7017 Technical Reference Manual

1.2.1

Prepare for System Checks

1. Check for any obvious problems such as a
recording paper jam,
telephone or data cable
loose at the terminal jacks or wall jack.
2. Ensure that handset is on handset cradle
and that power cord is connected to
terminal and to wall outlet.
3. If unable to perform any of the following
steps, go to 1.2.2 Off-Line System Check.
4. Enter service mode.
a. Press Menu.
b. Press on the key pad three times.
*
c. Press Stop.
d. Upper line of display
indicate terminal is in service mode.
5. Print the service option report (save for
Final Actions).
a. Press Menu.
b. On the keypad, press 2 then 2.
c. Press Start.
6. Set listen to dial to on.
RX NOTE: Perform this step only if listen to
dial is permitted in your country.
a. Press Menu.
b. On the keypad, press 4 then 5.
Display indicates:
45 LISTEN TO DIAL
PRESS [ENTER] OR [SCROLL]
c. Press Enter.
d. If listen to dial is on, go to next step.
If listen to dial is off, press Select to
change to on.
e. Press Enter.
Telecopier 7017 / 7017SF
7. Set key tone to on.
a. Press Menu.
original jam,
b. On the keypad, press 5 then 2.
connections
Display indicates:
52
PRESS [ENTER] OR [SCROLL]
c. Press Enter.
d. If panel key tone is on, go to next
step. If panel key tone is off, press
Select to change to on.
e. Press Enter.
8. Go to 1.2.2 Off-Line System Check.
blinks to
PANEL KEY TONE
8/88
Prepare for System Checks, Off-Line System Check
1-3
www.printcopy.info
1.2.2

Off-Line System Check

NOTE: If an error code (COXX, FPXX, EXXX, or
OPXX) appears at any time during this check,
do not continue. Refer to Section 2 for the
Error Code List and perform the actions
indicated.
1. Ensure that handset is on handset cradle.
Disconnect power cord from terminal,
wait five seconds, then reconnect power
cord to terminal. Observe red LED and
green LED of power supply come on.
(LEDs are visible through fan vent at rear
of terminal.)
Y N
| RAP 2.3.1
2. Power supply fan comes on.
Y N
| Replace fan.
3. Within 3 seconds display indicates:
Please WAIT
Telecopier 7017
Y N
| Replace A2, A6, A10.
4. Approximately 15 seconds after terminal
powers up, power supply fan and red LED
go off.
Y N
| RAP 2.3.12
5. ADF feed belt and nudger are stationary.
Y N
| Replace A2.