Removal From Service / Correct Disposal Of The Sensor; Removal From Service; Correct Disposal Of Unit - Thermo Scientific Scientific AquaSensors DataStick User Manual

The following advisories and warnings must be followed with all DataStick Products:
1.5

Removal from Service / Correct Disposal of the Sensor

1.5.1

Removal from Service

Disconnect the cable wiring. The metho
connection, just remove the connector. In the case of a screw terminal block, remove the black ground wire last.
Remove the sensor from the mounting hardware.
1.5.2

Correct Disposal of Unit

When the sensor is taken out of service, o
Thermo Scientific AquaSensors™ DataStick™ Measurement System User Guide
This equipment is suitable for use in Class I, Division 2,
Groups A, B, C, d or Non-Hazardous Locations Only
The equipment shall be supplied from a Class 2 power input.
The supply is from an isolated source, maximum 30 VDC.
DataStick bodies constructed from polymeric materials Noveon Corzan
Type 3218 shall not be used in applications exceeding a maximum
operating ambient of 50C.
Input and output wiring must be in accordance with Class I, Div.2 wiring
methods and in accordance with the authority having jurisdiction.
Warning: Explosion Hazard – Substitution of components may impair
suitability for Class I, Division 2.
Warning – Explosion Hazard – Do not disconnect equipment unless power
has been switched off or the area is known to be non-hazardous.
d for doing this will depend on the termination hardware that is chosen. In the case of a USB
bserve the local environmental regulations for correct disposal.
8