Section 1
Introduction
|
6
RDO Pro-X Optical Dissolved Oxygen Measurement System
|
Please contact Thermo Fisher Scientific or an authorized representative with any questions.
Intended Use
The RDO Pro-X Optical Dissolved Oxygen System is used for continuous monitoring dissolved
oxygen in applications where the range of measurement is between 0 ppm and 20 ppm. The
sensor also measures temperature.
Any other use, or use not mentioned here, that is incompatible with the technical
specifications is deemed inappropriate. The operator is solely responsible for any damage
arising from such use.
Other prerequisites for appropriate use include:
1. Observing the instructions, notes and requirements set out in this user guide.
2. Observing all local safety regulations.
3. Observing all warnings and cautions in the documentation regarding all products used in
this measurement system, including the sensor, mounting hardware, AV38 electronics and
cabling.
4. Observing the prescribed environmental and operational conditions.
5. Observing chemical compatibility with all wetted materials.
Safety Instructions
The system should be installed and operated only by personnel familiar with the
system and qualified for such work.
A defective system should be returned to Thermo Fisher Scientific for repair or
replacement. Contact Thermo Fisher Scientific to obtain a Return Material Authorization (RMA)
number.
No modifications to the system are allowed. Thermo Fisher Scientific accepts no responsibility
for damage caused by unauthorized modifications. The risk is borne entirely by the user.
Removal from Service/Correct Disposal of the
System
Removal from Service
Disconnect the cable wiring from the controller terminal block.
•
Remove the system from the mounting hardware.
•
Thermo Scientific AquaSensors