Thermo Scientific Scientific AquaSensors DataStick User Manual page 72

ASCII Commands to Set Sensor units
Function
Set to µS/cm
Set to %
Set to ppm
Set to MΩ·cm
All Set Commands will respond with "OK" if accepted and "ERROR" if not accepted
4 . 4 . 2 . 4 T E M P E R A T U R E U N I T S
Select TEMPERATURE UNITS from the Configuration pull-down menu to view or change units of measure.
Units shown in the temperature units window are active. To change units or to review options, scroll the selection list. Click on
the desired units of measure to place the new choice in the sensor units window. To accept the change, click OK. To abort the
change, click CANCEL.
Temperature can be displayed in °C or °F. Default units are °C.
ASCII Commands to View Temperature units
Function
View Temperature Units
ASCII Commands to Set Temperature units
Function
Set °C
Set °F
All Set Commands will respond with "OK" if accepted and "ERROR" if not accepted
Thermo Scientific AquaSensors™ DataStick™ Measurement System User Guide
Command Explanation
SSUNITS 0 Sensor data will be reported in µS/cm units
SSUNITS 1 Sensor data will be reported in % units
SSUNITS 2 Sensor data will be reported in ppm units
Sensor data will be reported in MΩ·cm units
SSUNITS 3
Command Response
GTUNITS 0
1
Command Explanation
STUNITS 0 Sensor data will be reported in °C
STUNITS 1 Sensor data will be reported in °F
Explanation
Data reported in °C
Data reported in °F
70