Table 4: Concentration Vs Conductivity After Editing - Thermo Scientific Scientific AquaSensors DataStick User Manual

Data for points 5 through 10 should be zero. Data stored in temporary memory can now be permanently stored using
the ACTIVATE STORED TABLE button.
If any error messages are shown, review the data points to be sure they are monotonic, that conductivity increases
from point 1 and that concentration increases or decreases from point 1.
Once the table has been activated, use the EXIT button and return to the main measure menu.
Table entries for specific chemicals are available from Thermo Fisher Scientific Customer Service on request.
The table entries made in this example are shown in Table 2.

Table 4: Concentration Vs Conductivity after Editing

Point Conductivity (µS/cm)
1
2 20,000
3 50,000
4 100,000
5
6
7
8
9
10
When the units of measure are set to "%" the conversion from conductivity to concentration will make use of the entered
table and will present the readings as shown.
Thermo Scientific AquaSensors™ DataStick™ Measurement System User Guide
Concentration %
0
50
70
97
0
0
0
0
0
0
0
0
0
0
0
0
0
76