Thermo Scientific Scientific AquaSensors DataStick User Manual page 87

Default units of measure are ppm.
ASCII Commands to View Sensor units
Function
View Sensor Units
ASCII Commands to Set Sensor units
Function
Set to ppm
Set to %
All Set Commands will respond with "OK" if accepted and "ERROR" if not accepted
4 . 5 . 2 . 4 T E M P E R A T U R E U N I T S
Select TEMPERATURE UNITS from the Configuration pull-down menu to view or change units of measure.
Units shown in the temperature units window are active. To change units or to review options, scroll the selection list.
Click on the desired units of measure to place the new choice in the sensor units window. To accept the change, click OK.
To abort the change, click CANCEL.
Temperature can be displayed in °C or °F. Default units are °C.
ASCII Commands to View Temperature units
Function
View Temperature Units
Thermo Scientific AquaSensors™ DataStick™ Measurement System User Guide
Command Response
GSUNITS 0
1
Command Explanation
SSUNITS 0 Sensor data will be reported in ppm units
SSUNITS 1 Sensor data will be reported in % concentration
Command Response
GTUNITS 0
1
Explanation
Data reported in ppm units
Data reported in % concentration
Explanation
Data reported in °C
Data reported in °F
85