Instructions For Use - Otto Bock 3R106-Pro Instructions For Use Manual

Signs of changes in or loss of functionality during use
Noticeable changes in functionality may include poor response, incomplete extension, diminished
swing phase control or stance phase stability, abnormal noises, etc.
4 Scope of delivery
The following single components and accessories are included in the scope of delivery in the spe­
cified quantities and are available for reordering as single components ( ), single components
with minimum order quantities ( ) or single-component packs ( ):
Fig. Item no.
–
1
1
1
–
1
–
The following parts are only for:
1
The following parts are for reorder only (not included in the scope of delivery!)
1
5 Preparation for use
5.1 Information on fabrication of a prosthesis
CAUTION
Incorrect alignment, assembly or adjustment
Injuries due to incorrectly installed or adjusted as well as damaged prosthetic components
► Observe the alignment, assembly and adjustment instructions.
Fabricating a prosthesis that is optimally tailored to the patient demands technical knowledge of
orthopaedic technology. The alignment and adjustments may only be carried out by a prosthetist.
The alignment and adjustments are mainly completed in the following steps:
1. Bench alignment
2. Static alignment
3. Dynamic trial fitting
These steps are first carried out with a test prosthesis in order to determine the best possible
combination and positioning of the prosthetic components relative to each other. Once all set­
tings have been tailored to the patient, the definitive prosthesis is produced. The same steps are
repeated for this purpose.
In dynamic trial fitting, the patient must be given sufficient time to become familiar with the func­
tions of the prosthesis, thereby learning safe use for everyday life.
Quant­ Designation
ity
1 Prosthetic Knee Joint
1 Tube Adapter
0 Adjustment Wrench
1 Compression Spring, heavy duty
1 Compression Spring, light duty
1

Instructions for Use

Prosthetic Knee Joint
1 Lamination Anchor
0 Single Component Pack
Consisting of:
1 Bumper
4 Truss Head Screw
4 Two-Hole Nuts
2 Set Screw
1 Set Screw
Reference number
–
2R49
710H10=2X3
513D83=1.4X12.6X66
513D83=1.1X12.9X66
647G208=1
3R106-Pro=KD
4G70
4D3
4Z81=4X12
501T1=M5X16
502R1=M5X16
506G3=M8X12-V
506G3=M8X10
Ottobock | 23