Table of Contents
Advertisement
Parameters
Note
Examples
Related Commands
measurement_
This option causes the system to pause until
complete
a pending measurement completes, or until a
< CTRL> -C signal is received. If a
measurement is not in progress, the wait
command will be completed immediately.
or
This causes the system to wait for a
< CTRL> -C signal or for a pending
measurement to complete. Whichever occurs
first will satisfy the condition.
< TIME>
This prompts you to enter the number of
seconds to insert for the delay.
seconds
This sets the unit of measure for the delay to
seconds. Seconds is the only option.
A wait command in a command file will cause execution of the
command file to pause until a < CTRL> -C signal is received, if
< CTRL> -C was previously defined as the interrupt signal.
Subsequent commands in the command file will not execute while
the command file is paused.
You can verify whether or not the interrupt signal is defined as
< CTRL> -C by typing "set" at the system prompt.
wait <RETURN>
wait 10 <RETURN>
none
Timing: Commands 9-91
Advertisement
Table of Contents
