Table of Contents
Advertisement
e xecute
1
Function
Default Values
Parameters
This command starts one or more timing measurements.
Syntax
The timing analyzer can make both single module or multiple
module measurements by using the execute and halt commands.
The execute command will start the timing analyzer alone (single
module measurement) if the timing analyzer is not connected to
the intermodule bus (IMB).
The execute command will start the timing analyzer and all other
modules connected to the IMB if the timing analyzer is connected
(trigger enable, trigger received, etc).
An execute command with no parameters will start an execution of
this module or if this module is connected to the IMB (trigger
enable, trigger received, etc.) the execution will start all modules
connected to the IMB.
repetitively
This option allows you to repetitively
execute measurements. This allows you to
accumulate measurements for statistical
analysis. As soon as one execution completes
another will be started until a "halt" is
executed from the command line or the
"halt_repetitive_execution" conditions are
met.
Timing: Commands 9-31
Advertisement
Table of Contents
