HP 64700 Series User Manual page 224

9-56 Timing: Commands
on_sample This option specifies the mark is to be
moved to the specified trace memory sample
number.
on_trigger This option specifies the mark is to be
moved to the current trigger location.
< PATT> This prompts you to enter a pattern of
signals. The pattern is a numerical value, the
significance of which is dependent on the
number of signals being tested. Refer to the
section on Entering Numerical Values in this
manual for options on entering patterns.
< SAMPLE> This prompts you to enter an integer sample
number.
start This parameter specifies the position of the
mark is to be after the start of trace memory.
< TIME> This prompts you for the time period to look
for a specified pattern.
nsec_of, These parameters specify the units of
usec_of, measurement of < TIME> in nanoseconds,
msec_of, microseconds, milliseconds, or seconds,
sec_of respectively.
trigger This parameter specifies the position of the
mark to be before or after the trigger.