HP 64700 Series User Manual page 257

Examples
Related Commands
the samples will be evenly distributed on
either side of the trigger.
start_of_trace This parameter positions the trigger near the
start of trace memory.
center_of_trace This parameter positions the trigger near the
middle of trace memory.
end_of_trace This parameter positions the trigger near the
end of trace memory.
QUALIFIER This qualifies the trigger condition by
allowing you to specify "edge conditions" on
labels or label bits which must occur before
the trigger condition will be evaluated. In
glitch capture mode, you specify signals on
which glitches will occur before the trigger
condition will be evaluated.
with Specifies that a glitch must occur on the
previously named channels while the
following condition is true.
< TIME> This prompts you to enter the time a signal
pattern should be evaluated.
nsec_of, These parameters specify the units of
usec_of, measurement of < TIME> in nanoseconds,
msec_of microseconds, or milliseconds, respectively.
trigger on pattern XBITS .0 = 0
qualified_with positive_edge XBITS .1
<RETURN>
trigger position_is center_of_trace
none
<RETURN>
Timing: Commands 9-89