Table of Contents
Advertisement
B-6 Timing Diagrams and Outputs
reverseVideo
Specifies that the foreground and
background colors should be reversed.
timingGeometry
Specifies the location and size to create the
timing analyzer's graphics subwindow. This
X default should not be used unless the
timing analyzer is positioning and/or sizing
it's graphics subwindow incorrectly. This can
occur if the terminal emulator window is
created with an unusually large internal
border or a left-justified scroll bar is being
used.
The geometry is specified as "= WxH+ X+ Y" indicating that the
window should have a width "W" and height "H" in pixels and the
upper left corner "X" pixels to the right and "Y" pixels below the
upper left corner of the terminal emulator window. "W" should be
set to 57 times the width of the terminal emulator's font cell and
"H" should be equal to 7 less than the total number of rows in the
terminal emulator window times the height of the font cell. "X"
should be set to 13 times the width of the font cell plus the width of
any internal border and left-justified scroll bar. "Y" should be
equal to the height of the font cell plus the width of any internal
border. Either "WxH" or "+ X+ Y"can be omitted to obtain the
default window size or window position as calculated by the timing
analyzer.
The timing analyzer attempts to match the foreground and
background colors used in the terminal emulator window by
recognizing the same X defaults used by "hpterm". The timing
analyzer will use these X defaults when they are not qualified with
the client name "hpterm" or when they are qualified with the timing
analyzer's client name "timing". For example, if your .Xdefaults file
contains the following lines:
*foreground:
green
*background:
blue
both the terminal emulator window and the timing analyzer's
graphics subwindow will use a blue background with green text
Advertisement
Table of Contents
