4-20 Performance Measurements
To configure the emulator to restrict to real-time runs, edit the
default configuration file:
$ chmod 644 config.EA <RETURN>
$ vi config.EA <RETURN>
Add a line which reads "Restrict to real-time runs? yes" just before
the memory map definition, save your changes, and exit out of the
editor.
Entering the Emulation System. If you have installed your
emulator and Softkey Interface software as directed in the HP
64700-Series Emulators Softkey Interface Installation Notice, you can
enter the emulation system.
If /usr/hp64000/bin is specified in your PATH environment
variable, you can enter the Softkey Interface with the following
command:
$ emul700 <emul_name> <RETURN>
The < emul_name> in the command above is the logical emulator
name given in the HP 64700 emulator device table
(/usr/hp64000/etc/64700tab).
Configuring the Emulator. Once you have entered the
emulation system, you can load the default emulator configuration
(copied and modified earlier) with the following command:
load configuration config <RETURN>
Loading the Demo Program. Enter the following command to
load the demo program:
load spmt_demo <RETURN>
Running the Demo Program. Finally, to run the demo program,
enter the following command:
run from transfer_address <RETURN>