HP 64700 Series User Manual page 50

Trace List
Label: Address Data
Base: hex hex
+015 000464
+016 000466
+017 000468
+018 000600
+019 000602
+020 00046A
+021 00046C
+022 00046E
+023 000470
sq adv 000472
sq adv 00040A
+026 00040C
+027 0006F8
+028 0006FA
+029 000450
STATUS: M68000--Running user program
trace enable 40ah disable anly.s:RAND+022h
run trace
2-26 Getting Started
that are called in that range or reads and writes to locations outside
that range.
When you use the windowing feature of the analyzer, the trigger
state must be in the window or else the trigger will never be found.
If you wish to combine the windowing and sequencing functions of
the analyzer, there are some restrictions:
Up to four sequence terms are available when windowing
is in effect.
Global restart is not available when windowing is in effect.
Occurrence counts are not available.
Suppose that you are only interested in the execution that occurs
within the RAND subroutine of the sample program. You could
specify the address of the subroutine call as the window enable
state and the address of the subroutine's last instruction as the
window disable state (and you could trigger on any state in that
window by not specifying a trigger). For example:
trace enable 40ah disable 472h <RETURN>
Offset=0
Opcode or Status
0000 0000 supr prog
0600 0600 supr prog
4240 CLR.W D0
091B 091B supr data wr word
576B 576B supr data wr word
4840 SWAP.W D0
0280 ANDI.L #0000000FF,D0
0000 0000 supr prog
00FF 00FF supr prog
4E75 RTS
6100 BSR.W 0000450
0044 0044 supr prog
0000 0000 supr data wr word
040E 040E supr data wr word
2039 MOVE.L 0000600,D0
step display
More data off screen (ctrl-F, ctrl-G)
mnemonic
Emulation trace complete______...R....
modify break
state count
relative
0
0
0
0
0
0
0
0
0
0
1
0
0
0
0
end ---ETC--