Table of Contents
Advertisement
p od_command
1
Function
____________________________________________________________________________
Care should be taken when using the "pod_command". The user interface, and
the configuration files in particular, assume that the configuration of the
64700 pod is NOT changed except by the user interface. Be aware that what
you see in "modify configuration" will NOT reflect the 64700 pod's
configuration if you change the pod's configuration with this command. Also,
commands which effect the communications channel should NOT be used at all.
Other commands may confuse the protocol depending upon how they are used.
The following commands are not recommended for use with "pod_command":
sttty, po, xp - do not use, will change channel operation and hang
echo, mac
- usage may confuse the protocol in use on the channel
wait
- do not use, will tie up the pod, blocking process
init, pv
- will reset pod and force end release_system
t
- do not use, will confuse trace status polling and unload
____________________________________________________________________________
Default Values
This command sends native commands to the analyzer.
Syntax
This command sends native commands to the analyzer terminal
interface. You should be very careful to avoid command which will
effect the interface or the configuration. Those commands would
"confuse" the protocol, and more likely than not, cause the analyzer
to hang.
The Softkey Interface provides the following warning when
displaying the pod_commands softkeys:
--- WARNING ---
none
Timing: Commands 9-61
Advertisement
Table of Contents
