HP 64700 Series User Manual page 238

9-70 Timing: Commands
off This option turns the process for data
condition off. When there is no process for
data condition, all of the samples in trace
memory are displayed in the trace list.
on This parameter qualifies the transition
condition by specifying a label name or label
bit number.
< PATT> This prompts you to enter a pattern of
signals. The pattern is a numerical value, the
significance of which is dependent on the
number of signals being tested. Refer to the
section on Entering Numerical Values in this
manual for options on entering patterns.
samples_of This option specifies that only samples
matching a specified pattern will be
displayed.
sampled This option specifies that only samples a
user-selected number of samples before or
after a specific condition will be displayed.
The condition can only be a transition
(positive, negative, or positive or negative)
on a specific signal.
< SAMPLE> This prompts you to enter a number of
samples before or after a specified event that
will be displayed.
samples_after This parameter specifies the displayed
samples are after the event specified.
samples_before This parameter specifies the displayed
samples are before the event specified.
neg_transition_on This parameter specifies a negative
transition on the target signal.