Table of Contents
Advertisement
C onfiguring the
1
External Analyzer
After you have assembled the external analyzer probe and
connected it to the emulator and target system, the next step is to
configure the external analyzer.
The external analyzer is a versatile instrument, and you can
configure it to suit your needs. For example, you can specify
threshold voltage levels on the external analyzer channels, and you
can operate the external analyzer in several different modes. The
external analyzer configuration options allow you to:
Specify the threshold voltages for the external channels.
Select the external analyzer mode.
Specify the slave clock mode (only if the "state" external
analyzer mode is selected).
Define external analyzer labels.
The default configuration specifies that the external analyzer is
aligned with the emulation analyzer. TTL level threshold voltages
are defined, as well as an external label named "xbits" which
contains all 16 channels.
To modify the external analyzer configuration, enter the following
command:
modify configuration <RETURN>
Now, press the < RETURN> key until you see the following
question. (If you pass this question, you can use the RECALL
softkey to back up to it.)
Modify external analyzer configuration?
Pressing the "yes" softkey causes the external analyzer
configuration questions to be asked. These questions are described
in the paragraphs that follow.
Using the External Analyzer 5-7
Advertisement
Table of Contents
