Installation; Entering The Timing Analyzer Softkey Interface - HP 64700 Series User Manual

64000-ux case solutions for microprocessors, softkey interface
Hide thumbs Also See for 64700 Series:
Table of Contents

Advertisement

Installation

E ntering the
1
Timing Analyzer
Softkey Interface
Note
7-2 Timing: Getting Started
The Timing Analyzer Softkey Interface is included with the Softkey
Interface software for you emulator. Refer to the HP 64700-Series
Emulators Softkey Interface Reference for information on installing
the software and hardware.
If you are using the Timing Analyzer with the X Window System,
refer to Installing X on the Series 300: Version 11, or the equivalent
manual for your system.
To enter the Timing Analyzer Softkey Interface, you must enter the
Softkey Interface as you normally enter the Emulator Softkey
Interface. For example, you would enter:
$ emul700 em68k
at the HP-UX prompt. This initializes the emulator and loads the
configuration. If you have not already modified the configuration
for the external analyzer, you should do so here. Refer to chapter 5
"Using the External Analyzer" for information on configuring the
external analyzer.
After the configuration for external timing has been loaded, exit
out of the interface locked, and then enter the Timing Analyzer
Softkey Interface with the following command:
$ emul700 -u sktiming em68k <RETURN>
The Timing Analyzer Softkey Interface can also be entered within
an X Window System window, or as a "measurement system"
option. The commands listed earlier can be entered at the "$"
prompt within a X Windows window. Refer to appendix B "Timing
Output and Diagrams" for information on setting up the X
Windows System. For information on adding the Timing Analyzer
to your measurement system, refer to your Emulation/Internal
Analysis Operating Manual.
<RETURN>

Advertisement

Table of Contents
loading

Table of Contents