Komatsu Galeo PC138US-8 Shop Manual page 912

SEN02715-00
a After installing front window glass (5),
install the center trim seal to its bot-
tom. Then, apply caulking material all
a r ou nd t he g la s s to fi ll par t ( U)
between the glass and center trim
seal.
a When caulking, neatly arrange the
form of the adhesive at the right and
left ends with a rubber spatula.
2
Adhesive:
Sikaflex 256HV manufactured
8. Fix the window glass.
1) After installing right window glass (1) to
the operator's cab, insert stopper rubbers
X2 to 2 places (v) at the bottom of the
glass to fix the glass.
(The figure shows the operator's cab of PC200-
7.)
12
by Sika Japan
9.
10. Protect the stuck window glass.
50 Disassembly and assembly
(The figure shows the operator's cab of PC200-
7.)
2) Using styrene foam blocks [9] and rubber
bands [10], fix the window glass and both-
sided adhesive tape of fit them completely.
(The figure shows the operator's cab of PC200-
7.)
After installing the window glass, remove the
primer and adhesive from the operator's cab
and window glass.
a Using white gasoline, wipe off the adhe-
sive before it is dried up.
a When cleaning the glass, do not give an
impact to it.
1) Keep the stopper rubbers, styrene form
blocks, and rubber bands installed for 10
hours (at temperature of 20°C and humid-
ity of 60%).
2) After removing the stopper rubbers, sty-
rene foam blocks, and rubber bands, wait
at least 14 hours, at least 24 hours in total,
before operating the machine actually.
PC138US, USLC-8