Komatsu Galeo PC138US-8 Shop Manual page 423

30 Testing and adjusting
Default (Camera)
Check or change various settings related to the
machine monitor and machine by "Default".
The camera setting function is used to set installa-
tion and removal of a camera.
1. Selecting menu
Select "Default" on the "Service Menu" screen.
2. Selecting sub menu
After the "Default" screen is displayed, select
"Ca mer a" with the fu ncti on s witc hes or
numeral input switches.
a Select this item similarly to an item on the
"Service Menu" Screen.
PC138US, USLC-8
3. Selecting camera setting
After the "Camera" setting screen is displayed,
select the setting with the function switches.
OFF: Camera is not used
q
Original Image: Image of connected cam-
q
Reverse Image: Image of connected cam-
q
[F3]: Move to left item
q
[F4]: Move to right item
q
[F5]: Cancel setting before confirmation
q
and return to "Default" screen
[F6]: Confirm selection in each line
q
a After "Camera" screen is displayed, cam-
era 1 can be always set.
a After confirming the setting of each line
with [F6], return to the "Default" screen
with [F5], and the setting is effective.
a If a camera is connected but not set nor-
mally with this function, the graphic mark
of camera is not displayed at [F3] in the
operator mode. Accordingly, the image of
the camera cannot be used.
a When a camera is installed, check that the
displayed image is not inverted horizon-
tally.
SEN02459-00
era is displayed in origi-
nal position (as in mirror,
used as back monitor)
era is displayed in reverse
position (as seen directly,
used as front or side mon-
itor)
41