Komatsu Galeo PC138US-8 Shop Manual page 866

SEN02713-00
10. Removal procedures of work equipment
pump
Remove work equipment pump by pulling it
toward the front according to the following pro-
cedures.
1) Shift the pump closer to the front end until
wire rope [2] almost makes contact with
the counterweight.
2) Pull chain block [1] up and loosen wire
rope [2].
3) Disconnect wire rope [2] from the work
equipment pump.
10
50 Disassembly and assembly
4) Install wire rope [2] to the work equipment
pump from outside the counterweight.
a Apply rubber plates or cloth [3] to the
counterweight to prevent it from being
damaged by wire rope.
5) Lower chain block [1] and hold the work
equipment pump in level state.
6) Shift the pump closer to the front end until
chain block [1] almost makes contact with
the counterweight.
7) Lower the chain block [1] and loosen
chain block [1].
PC138US, USLC-8