Komatsu Galeo PC138US-8 Shop Manual page 908

SEN02715-00
a Parts to be coated with primer: Apply
the primer to the sticking surfaces of
window glass (9) and all over dimen-
sion (d) which will be on both-sided
adhesive tape (7) and operator's cab
(8).
a Do not apply the primer to the
boarder about 5 mm wide between
the black part and transparent part of
the glass.
a After applying the primer, leave it for
at least 5 minutues (within 8 hours) to
dry.
a Never apply wring the primer. If the
glass primer is applied by mistake,
wipe it off with white gasoline.
4. Stick both-sided adhesive tape (7) along the
inside edge of the glass sticking section.
a Do not remove the release tape of the
both-sided adhesive tape on the glass
sticking side before stiking the glass.
a When sticking the both-sided adhesive
tape, do not touch the cleaned surface as
long as possible.
a Take that the both-sided adhesive tape will
not float at each corner of the window
frame.
8
50 Disassembly and assembly
a When sticking both-sided adhesive tape
(7) around a frame, do not lap its finishing
end over the starting end but make clear-
ance e of about 5 mm between them.
1) Stick both-sided adhesive tape (7) for right
side window glass (1) as shown in the fig-
ure.
a Stick both-sided adhesive tape (7a) addi-
tionally for right side window glass (1).
Positions to stick additional both-sided
q
adhesive tape for right side window glass.
(f) : 140 mm
(g): 500 mm
2) Stick both-sided adhesive tape (7) for left
side rear window glass (2) as shown in the
figure.
PC138US, USLC-8