Komatsu Galeo PC138US-8 Shop Manual page 832

SEN02711-00
5. Carrier No. 2 assembly
1) Sub-disassembly of carrier No. 2 assem-
bly
1] Assemble bearing (25) to gear (24).
2] Install thrust washer (23) and (26)
and set gear assembly to carrier (22).
3] Align the shaft to the carrier pin hole
position, and install shaft (21) by
lightly hammering with a plastic ham-
mer, etc.
a Install the shaft by turning the
planetary gear. Be careful not to
damage the thrust washer.
4] Insert pin (20).
a Insert the pin, then caulk the pin
of the carrier.
2) Install carrier No. 2 assembly (19) to the
shaft and case assembly.
3) Install spacer (18).
10
50 Disassembly and assembly
6. Ring gear
Install O-ring (40) to the shaft and case assem-
bly, and install ring gear (17).
7. Carrier No. 1 and sun gear No. 2 assembly
1) Sub-disassembly of carrier No. 1 and sun
gear No. 2 assembly
1] Install carrier No. 1 (16) to sun gear
No. 2 (15) and Install snap ring (14).
2] Align the shaft to the carrier pin hole
position, and install shaft (21) by
lightly hammering with a plastic ham-
mer, etc.
3] Insert pin (12).
a Insert the pin, then caulk the pin
of the carrier.
a Check that difference (a) between
the shaft and carrier is 0.2 mm or
less.
PC138US, USLC-8