Komatsu Galeo PC138US-8 Shop Manual page 911

50 Disassembly and assembly
4) Remove the release tape of the both-
sided adhesive tape on the glass side.
5) Apply adhesive (15) to the outside of both-
sided adhesive tape (7) of the operator's
cab.
a Apply adhesive (15) to dimensions s
and t of both-sided adhesive tape (7)
of operator's cab (8).
Dimension (s): 10 mm
q
Dimension (t) : 15 mm
q
a Apply adhesive (15) higher than both-
sided adhesive tape (7).
a Apply the adhesive evenly.
a As for the right side window glass,
apply the adhesive to the outside of
the both-sided adhesive tape on the
periphery of the glass.
PC138US, USLC-8
7. Install the window glass.
1) Install window glass (9), matching it to the
lines of the positioning tapes drawn in step
5.
a Sine the window glass cannot be
removed and stuck again, stick it very
carefully.
a Stick the glass within 5 minutes after
applying the adhesive.
2) After sticking window glass (9), press all
around it until it is stuck to the both-sided
adhesive tape.
a Press the corners of the window glass
firmly.
a You can perform this work efficiently
by pulling window glass (9) from
inside of the operator's cab with suc-
tion cup X1.
(The figure shows the operator's cab
of PC200-7.)
SEN02715-00
11