Komatsu Galeo PC138US-8 Shop Manual page 833

50 Disassembly and assembly
4] Install thrust washer (11), bearing
(10), gear (9) and thrust washer (8),
and install snap ring (7).
a Use new snap ring.
a ?hen installing the snap ring, do
not allow the mating space to
expand wider than 11 mm to pre-
vent the snap ring from deform-
ing.
a After installation, check that the
snap ring is firmly in place.
2) Install carrier No. 1 and sun gear No.2
assembly (6) to the shaft case assembly.
3) Install sun gear No. 1 (5).
PC138US, USLC-8
8. Swing motor assembly
1) Install swing motor assembly (4).
2) Install 15 swing motor mounting bolts (3).
3
Swing motor mounting bolt:
110.3 ± 12.3 Nm {11.25 ± 1.25 kgm}
3) Install hose (2).
4) Install oil level pipe (1).
9. Refilling with oil
Tighten the drain plug, and refill engine oil
E030 from the oil filler port.
5
Swing machinery case: 2.5 l l l l
SEN02711-00
11