50 Disassembly and assembly
3)
Stick both-sided adhesive tape (7) for door
upper window glass (3) and lower window
glass (4) as shown in the figure.
(The figure shows the door upper window
glass.)
(The figure shows the door lower window
glass.)
4)
Stick both-sided adhesive tape (7) for front
window glass (5) as shown i the figure.
a Both-sided adhesive tape: 1,004 mm
× 2 pieces
PC138US, USLC-8
Details of the sticking positions are as
q
follows.
(h): Stick to inside end of right and left
front frames (17).
(j) : Retract by "3.0 mm" from the end
of front frame (17).
5.
Possition the new window glass.
1)
Check the clearance between the window
glass and the operator's cab on the right,
left, upper, and lower sides, and then
adjust it evenly.
2)
Stick tapes [6] between window glass (9)
and operator's cab (8) and draw position-
ing line (n).
a Stick tapes [6] to the right, left, and
lower parts of the right side window
glass, left side rear window glass, and
door lower window glass for accurate
positioning.
3)
Cut the tape between window glass (9)
and operator's cab (8) with a knife, and
then remove the window glass.
a Do not remove the tapes left on the
window glass and operator 's cab
before installing the window glass.
SEN02715-00
9