Komatsu Galeo PC138US-8 Shop Manual page 416

SEN02459-00
Maintenance Mode Change
The operating condition for maintenance function in
the operation mode can be set and changed with
this menu.
Set function effective or ineffective
q
Change set replacement interval (by items)
q
Initialize all set replacement intervals
q
1. Selecting menu
Select of "Maintenance Mode
"Service Menu" screen.
2. Selecting sub menu
After the "Maintenance Mode Change" screen
is displayed, select an item to change the set-
ting with the function switches or numeral input
switches.
[F1]: Move to next page (screen)
q
[F2]: Move to previous page (screen)
q
[F3]: Move to lower item
q
[F4]: Move to upper item
q
[F5]: Return to service menu screen
q
a You may enter a 2-digit code with the
numeral input switches to select the item
of that code and confirm it with [F6].
34
" on the
Change
3.
30 Testing and adjusting
a The following items can be selected on
the Change of maintenance mode screen.
00 Maintenance mode on/off
01 Engine oil change int.
02 Engine oil filter change int.
03 Fuel main filter change int.
41 Fuel pre filter change int.
04 Hyd oil filter change int.
05 Hyd tank breather change int.
06 Corrosion resistor change int.
07 Damper case service int.
08 Final drive case oil change int.
09 Machinery case change int.
10 Hydraulic oil change int.
99 Initialize all items
Contents of setting of Maintenance mode on/
off
After selecting "Maintenance Mode On/Off", if
the screen is displayed, set ON or OFF with
the function switches.
ON: Functions of all maintenance items
q
are set effective in operator mode
OFF: Functions of all maintenance items
q
are set ineffective in operator mode
[F3]: Move to lower item
q
[F4]: Move to upper item
q
[F5]: Cancel selection and return to Main-
q
tenance mode change screen
[F6]: Confirm selection and return to
q
Maintenance mode change screen
a Even if ON/OFF of each item has been
set, if the above setting is changed, it is
applied.
PC138US, USLC-8