Remote Options; Remote Key; Remote Disarm; App Key - DMP Electronics CellCom-LTE-V SERIES Installation And Programming Manual

REMOTE OPTIONS

8.1
REMOTE OPTIONS
8.2
RMT KEY:
8.3
DISARM NO
8.4

APP KEY:

Digital Monitoring Products
18
Remote Options
Remote Options
This section allows you to enter the information needed for Remote Command/Remote
Programming operation.

Remote Key

This option allows you to enter a code of up to eight digits for use in verifying the
authority of a receiver to perform a remote command/programming session. The
receiver must give the correct key to the communicator before being allowed access. All
CellCom-LTE-V Communicators are shipped from the factory with the Remote Key preset
as blank.
To enter a new Remote Key, press any select key and enter any combination of up to 8
digits. The numbers you enter appear as asterisks.

Remote Disarm

YES
Enter YES to enable the communicator to be disarmed remotely. Selecting NO disables
remote disarming.
App Key
Enter the 8-digit App Key obtained in your Dealer Settings on the Dealer Admin site.
(DMPDealerAdmin.com) This option is a security feature of the Virtual Keypad App and
is used only when your Dealer Settings on the Dealer Admin Site have "EASYconnect"
set as the Communication Type. This communication option is only available for XT
panels with onboard network and is used to eliminate the need for a static IP address
programmed in Network Options. To enter a new App Key, press any select key and enter
any combination of 8 digits. (Default is blank)
CellCom- LTE-V Series Installation and Programming Guide