Optimize (Opt) - DMP Electronics CellCom-LTE-V SERIES Installation And Programming Manual

5. Select YES to to allow receipt of Z-Wave devices to your system. The keypad displays TRANSFERRING Z-WAVE
DEVICES. Pressing the Back Arrow key cancels the transfer. Select NO to exit the XFER menu and return to
ZWAVE SETUP?. All programming will still be intact on the DMP Z-Wave controller and will cancel the transfer.
6. Initiate the transfer at the other manufacturer's Z-Wave portable controller. All Z-Wave devices are added
to the system with a default name (device type and number). A 16-character name may be assigned to the
Z-Wave devices after the transfer is complete. When the transfer is complete the screen will display ZWAVE
SETUP?.
Note: If TRANSMISSION FAILED displays on the screen, your system memory is cleared of all prior Z-Wave
devices programming and will need to add each Z-Wave device individually.

16.13 Optimize (OPT)

Select Optimize (OPT) to update communication with all Z-Wave devices. Optimize can be used to re-establish
communication after a Z-Wave device has been moved to a different location. When OPT is selected, the
CellComZ-LTE-V makes three attempts to communicate with each Z-Wave device. Z-Wave devices that fail to
communicate during the optimize process are not removed from CellComZ-LTE-V programming.
1. Access the User Menu.
2. Press CMD until ZWAVE SETUP? displays.
3. Press any Select key. The keypad displays ADD LIST REMOVE.
4. Press CMD again to display FAV XFER OPT.
5. Select OPT, the keypad displays OPTIMIZE while the system is searching for Z-Wave devices.
6. The keypad will display OPTIMIZE SUCCESS when Z-Wave devices have been retrieved.
7. Press CMD to return to ZWAVE SETUP?.
Note: The keypad will display OPTIMIZE FAILED when communication with a Z-Wave device is not established. Press
CMD to return to ZWAVE SETUP? and attempt optimize again. If communication with a Z-Wave device is not re-
established during the optimize process, make sure the device is powered on. If the device that failed has power,
add a repeater between the CellComZ-LTE-V and the device.
CellCom -LTE-V Series Installation and Programming Guide
Z-WAVE SETUP
Digital Monitoring Products
33