Configuring Settings For Ir Illumination - Bosch MIC IP starlight 7000i User Manual

66 en | Using your MIC Camera
11.7

Configuring Settings for IR Illumination

The following table provides the valid combinations of settings for activating IR illumination.
To activate IR illumination, set the menus Night Mode, IR Illuminator, and IR Focus Correction
to the values identified in the table below, depending on your desired results.
Menu
Model: MIC camera with IR
Setting
Model: MIC camera without IR
Setting
There are no other valid combinations. Any other combination can cause the camera to have
problems focusing ("focus issues").An example of an invalid combination is:
–
–
–
This combination of settings causes a blurred view at wide angle. (When zoomed in (at TELE
angle), the view is focused.)
2017.11 | 1.2 |
Night IR
Mode Illuminator
Auto Auto
Auto Off
Off Auto
Auto --
Night Mode = Auto
IR Illuminator = Auto
IR Focus Correction = Off
RESULTS
IR Focus
Correction
Auto (or Within 10 seconds of
ON if Auto switching to Night
not Mode, the IR lamps
available) turn on.
Auto (or IR lamps turn on with
ON if Auto Aux 54 or alarms.
not
available)
Auto (or Camera enters Night
ON if Auto Mode with Aux 57 or
not alarms.
available)
On When using external IR
lamps, user must
control the IR Focus
Correction using Aux
67 or alarms.
User Manual
MIC IP starlight 7000i
Notes
This is the
recommended
configuration.
Use this for manual
control of the IR lamps.
Use this for manual
control of Night Mode.
For control of IR Focus
Correction with a MIC
camera (non-IR).
Bosch Security Systems