Using The Web Interface - Cisco 7010 Installation Manual

Chapter 4 Installing a Firepower Managed Device
•
•
To implement your changes, reboot the appliance by typing
Step 3
The appliance reboots.

Using the Web Interface

You can also redirect console output through the web interface.
To redirect the console output using the web interface:
Select
Step 1
Select
Step 2
Select a remote console access option:
Step 3
•
•
•
To configure LOM via SOL, enter the appropriate settings:
Step 4
•
•
•
•
Step 5 Click
Remote console configuration for the appliance is saved. If you configured Lights-Out Management, you
must enable it for at least one user; see
sudo /usr/local/sf/bin/configure_console.sh vga
To access the appliance using the physical serial port:
sudo /usr/local/sf/bin/configure_console.sh serial
To access the appliance using LOM via SOL:
sudo /usr/local/sf/bin/configure_console.sh sol
Access: Admin
System > Configuration.
Console Configuration.
Select to use the appliance's VGA port. This is the default option.
VGA
Select to use the appliance's serial port, or to use LOM/SOL on a Firepower 7050
Physical Serial Port
or 8000 Series device.
The LOM settings appear.
Select
Lights-Out Management
On these devices, you cannot use SOL and a regular serial connection at the same time. LOM
settings appear.
for the appliance (
DHCP Configuration
IP Address to be used for LOM. The LOM IP address must be different from the management
interface IP address of the appliance.
for the appliance.
Netmask
Default Gateway for the appliance.
Save .
to use LOM/SOL on a 7000 Series device (except the Firepower 7050).
or ).
DHCP Static
Enabling LOM and LOM Users, page
Firepower 7000 and 8000 Series Installation Guide
Redirecting Console Output
.
sudo reboot
8-16.
4-23