Cisco 7010 Installation Manual page 116

Firepower 7000 Series Devices
Table 7-14
Status
Both LEDs off
Link amber
Link green
Activity blinking green
Use the following table to understand the bypass LED on the copper interfaces.
Table 7-15
Status
Off
Steady green
Steady amber
Blinking amber
Figure 7-9
Use the following table to understand the link and activity LEDs on the fiber interfaces.
Table 7-16
Status
Top (activity)
Bottom (link)
Use the following table to understand the activity and link LEDs on the fiber interfaces.
Table 7-17
Status
Off
Steady green
Firepower 7000 and 8000 Series Installation Guide
7-10
Firepower 7110 and 7120 Copper Link/Activity LEDs
Description
The interface does not have link.
The speed of the traffic on the interface is 10Mb or 100Mb.
The speed of the traffic on the interface is 1Gb.
The interface has link and is passing traffic.
Firepower 7110 and 7120 Copper Bypass LED
Description
The interface pair is not in bypass mode or has no power.
The interface pair is ready to enter bypass mode.
The interface pair has been placed in bypass mode and is not inspecting
traffic.
The interface pair is in bypass mode; that is, it has failed open.
Eight-Port 1000BASE-SX Fiber Configurable Bypass Interfaces
Firepower 7110 and 7120 Fiber Link/Activity LEDs
Description
For an inline interface: the light is on when the interface has activity. If dark,
there is no activity.
For a passive interface: the light is non-functional.
For an inline or passive interface: the light is on when the interface has link.
If dark, there is no link.
Firepower 7110 and 7120 Fiber Bypass LEDs
Description
The interface pair is not in bypass mode or has no power.
The interface pair is ready to enter bypass mode.
Chapter 7 Hardware Specifications