Inserting A Module Or Slot Cover - Cisco 7010 Installation Manual

Inserting a Module or Slot Cover

Inserting a Module or Slot Cover
Before You Begin
•
To insert a module or slot cover:
Remove and reserve the T8 Torx screw from the lever of the module using the included screwdriver.
Step 1
Pull the lever away from the module to open the latch. The near end of the latch is visible. The far end
Step 2
of the latch is inside the module.
Step 3 Insert the module into the slot until the far end of the latch is inside the slot and the near end of the latch
touches the outside of the module slot.
Firepower 7000 and 8000 Series Installation Guide
C-6
Remove the existing module or slot cover to prepare the slot for a new module. See
Module or Slot Cover, page C-5
Appendix C Inserting and Removing Firepower 8000 Series Modules
for more information.
Removing a