Cisco 7010 Installation Manual page 130

Firepower 8000 Series Devices
Figure 7-19
Table 7-35
A
B
C
D
E
The front panel of the chassis houses LEDs, which display the system's operating state. The following
table describes the LEDs on the front panel
Table 7-36 Firepower 8000 Series Front Panel LEDs
LED
NIC activity
Hard drive activity
System status
Firepower 7000 and 8000 Series Installation Guide
7-24
Firepower 82xx Family and Firepower and AMP 83xx Family Front Panel
Firepower 8000 Series Front Panel Components
NIC activity LED
Reserved
Hard drive activity LED
System status LED
Non-maskable interrupt button
Description
Indicates whether there is any network activity:
Green indicates there is network activity.
•
If the light is off, there is no network activity.
•
Indicates the hard drive status:
Blinking green indicates the fixed disk drive is active.
•
• Amber indicates a fixed disk drive fault.
• If the light is off, there is no drive activity or the system is powered off.
Indicates the system status:
Green indicates the system is operating normally.
•
Blinking green indicates the system is operating in a degraded condition.
•
Blinking amber indicates the system is in a non-critical condition.
•
Amber indicates the system is in a critical or non-recoverable condition, or the system is
•
starting up.
If the light is off, the system is starting up or off.
•
The amber status light takes precedence over the green status light. When the amber
Note
light is on or blinking, the green light is off.
See Table 7-37 on page 7-25
F
G
H
I
for more information.
Chapter 7 Hardware Specifications
Reset button
ID button
Power button and LED
USB 2.0 connector