Cisco 7010 Installation Manual page 145

Chapter 7 Hardware Specifications
Table 7-56
Status
Top
(Activity)
Bottom
(Link)
Use the following table to understand the optical parameters of the fiber interfaces.
Table 7-57
Parameter
Optical connectors
Bit rate
Baud rate/encoding/tolerance
Optical interface
Operating distances
Transmitter wavelength
Maximum average launch power
Minimum average launch power
Maximum average power at receiver
Receiver sensitivity
Quad-Port 10GBASE (MMSR or SMLR) Fiber Non-Bypass NetMod
The quad-port 10GBASE (MMSR or SMLR) fiber non-bypass NetMod contains four fiber ports, and
link and activity LEDs.
The quad-port 10GBASE non-bypass NetMod contains non-removable SFPs. Any attempt to remove the
Caution
SFP may damage the module.
Use the following table to understand the link and activity LEDs on fiber interfaces.
Non-Bypass Fiber Link/Activity LEDs
Description
For an inline or passive interface: the light flashes when the interface
has activity. If dark, there is no activity.
For an inline interface: the light is on when the interface has link. If
dark, there is no link.
For a passive interface: the light is always on.
1000BASE-SX NetMod Optical Parameters
1000BASE-SX
LC duplex
1000Mbps
1250Mbps
8b/10b encoding
Multimode
656 ft (200 m) for 62.5 µm/125 µm fiber
1640 ft (500 m) for 50 µm/125 µm fiber
770-860 nm (850 nm typical)
0 dBm
-9.5 dBm
0 dBm
-17 dBm
Firepower 7000 and 8000 Series Installation Guide
Firepower 8000 Series Devices
7-39