Cisco 7010 Installation Manual page 123

Chapter 7 Hardware Specifications
Table 7-26
Status
Both LEDs off
Link amber
Link green
Activity blinking green
Use the following table to understand the bypass LED on copper interfaces.
Table 7-27
Status
Off
Steady green
Steady amber
Blinking amber
SFP Interfaces
You can install up to eight hot-swappable Cisco SFP transceivers, available in 1G copper, 1G short range
fiber, or 1G long range fiber. SFP transceivers do not have bypass capability and should not be used in
intrusion prevention deployments. See
page B-1
Figure 7-14
Use the following table to understand the fiber LEDs.
Firepower 7115, 7125, and AMP7150 Copper Link/Activity LEDs
Description
The interface does not have link.
The speed of the traffic on the interface is 10Mb or 100Mb.
The speed of the traffic on the interface is 1Gb.
The interface has link and is passing traffic.
Firepower 7115, 7125, and AMP7150 Copper Bypass LED
Description
The interface pair is not in bypass mode or has no power.
The interface pair is ready to enter bypass mode.
The interface pair has been placed in bypass mode and is not inspecting
traffic.
The interface pair is in bypass mode; that is, it has failed open.
for more information.
Sample SFP Transceivers
Using SFP Transceivers in 3D71x5 and AMP7150 Devices,
Firepower 7000 and 8000 Series Installation Guide
Firepower 7000 Series Devices
7-17