Cisco 7010 Installation Manual page 146

Firepower 8000 Series Devices
Table 7-58
Status
Top
Bottom
Use the following table to understand the optical parameters of the fiber interfaces.
Table 7-59 10GBASE MMSR and SMLR NetMod Optical Parameters
Parameter
Optical connectors
Bit rate
Baud rate/
encoding/tolerance
Optical interface
Operating distance
Transmitter wavelength
Maximum average launch
power
Minimum average launch
power
Maximum average power
at receiver
Receiver sensitivity
Stacking Module
The stacking module contains two connection ports for the 8000 Series stacking cable, and activity and
link LEDs.
Firepower 7000 and 8000 Series Installation Guide
7-40
Fiber Link/Activity LEDs
Description
For an inline or passive interface: the light flashes when the interface has
activity. If dark, there is no activity.
For an inline interface: the light is on when the interface has link. If dark, there
is no link.
For a passive interface: the light is always on.
10GBASE MMSR
LC duplex
10.000Gbps
10.3125Gbps
64/66b encoding
+/- 100 ppm
Multimode
840-860 nm
(850 nm typical)
85 ft (26 m) to 108 ft (33 m) for 62.5 µm/125 µm fiber
(modal BW 160 to 200 respectively)
216 ft (66 m) to 269 ft (82 m) for 50 µm/125 µm fiber
(modal BW 400 to 500 respectively)
Distances to 980 ft (300 m) are available with higher
quality (OM3) fiber.
Minimum distances (all):
6ft (2 m)
840-860 nm
(850 nm typical)
-1 dBm
-7.3 dBm
-1 dBm
-9.9 dBm
Chapter 7 Hardware Specifications
10GBASE SMLR
LC duplex
10.000Gbps
10.3125Gbps
64/66b encoding
+/- 100 ppm
Single mode only
1270-1355 nm
(1310 nm typical)
6 ft to 6.2 miles (2 m to 10 km)
for 9 µm/125 µm fiber
1270-1355 nm
(1310 nm typical)
-0.5 dBm
-8.2 dBm
-0.5 dBm
-14.4 dBm