Next Steps - Cisco 7010 Installation Manual

Next Steps

When prompted, enter a name for the configuration.
Step 3
What to Do Next
•
To load a saved restore configuration:
From the main menu, select
Step 1
The utility presents a list of saved restore configurations. The first option,
configuration you last used to restore the appliance. The other options are restore configurations that you
have saved.
Step 2 Select the configuration you want to use.
The utility displays the settings in the configuration you are loading.
Step 3 When prompted, confirm that you want to load the configuration.
The configuration is loaded. If prompted, confirm the IP address assigned to the appliance's management
interface.
What to Do Next
•
Next Steps
Restoring your appliance to factory default settings results in the loss of almost all configuration and
event data on the appliance, including bypass configurations for devices deployed inline. For more
information, see
After you restore an appliance, you must complete an initial setup process:
•
•
Note that deleting license and network settings also resets display (console) and LOM settings=. After
you complete the initial setup process:
•
•
Firepower 7000 and 8000 Series Installation Guide
8-14
To use the configuration you just saved to restore the appliance, continue with
and Update Files and Mounting the Image, page
7 Load Configuration
To use the configuration you just loaded to restore the appliance, continue with
ISO and Update Files and Mounting the Image, page
Traffic Flow During the Restore Process, page
If you did not delete the appliance's license and network settings, you can use a computer on your
management network to browse directly to the appliance's web interface to perform the setup. For
more information, see Initial Setup Page: Firepower Devices, page
If you deleted license and network settings, you must configure the appliance as if it were new,
beginning with configuring it to communicate on your management network. See
Firepower Managed Devices, page
If you want to use a serial or SOL/LOM connection to access your appliance's console, you should
redirect console output; see
If you want to use LOM, you must re-enable the feature as well as enable at least one LOM user;
see Enabling LOM and LOM Users, page
Chapter 8 Restoring a Firepower System Appliance to Factory Defaults
8-11.
.
8-11.
5-1.
Testing an Inline Bypass Interface Installation, page
8-16.
Downloading the ISO
, is the
default_config
Downloading the
8-1.
5-5.
Setting Up
4-24.