Cisco 7010 Installation Manual page 140

Firepower 8000 Series Devices
Table 7-46
Status
Top
Bottom
Use the following table to understand bypass LEDs on the fiber interfaces.
Table 7-47
Status
Off
Steady green
Steady amber
Blinking amber
Use the following table to understand the optical specifications of the fiber interfaces.
Table 7-48
Parameter
Optical connectors
Bit rate
Baud rate/encoding/tolerance
Optical interface
Operating distances
Transmitter wavelength
Maximum average launch power
Minimum average launch power
Maximum average power at receiver
Receiver sensitivity
Firepower 7000 and 8000 Series Installation Guide
7-34
Fiber Link/Activity LEDs
Description
For an inline or passive interface:
• A blinking light indicates the interface has activity.
• No light indicates there is no activity.
For an inline interface:
A light indicates the interface has activity.
•
No light indicates there is no activity.
•
For a passive interface, the light is always on.
Fiber Bypass LEDs
Description
The interface does not have link and is not in bypass mode.
The interface has link and is passing traffic.
The interface has been intentionally brought down.
The interface is in bypass mode; that is, it has failed open.
1000BASE-SX NetMod Optical Parameters
Chapter 7
1000BASE-SX
LC duplex
1000Mbps
1250Mbps
8b/10b encoding
Multimode
656 ft (200 m) for 62.5 µm/125 µm fiber
1640 ft (500 m) for 50 µm/125 µm fiber
770-860 nm (850 nm typical)
0 dBm
-9.5 dBm
0 dBm
-17 dBm
Hardware Specifications