Cisco 7010 Installation Manual page 110

Firepower 7000 Series Devices
Sensing Interfaces
The Firepower 70xx Family appliances are delivered with eight copper interfaces, each with
configurable bypass capability.
Figure 7-3
Use the following table to understand the activity and link LEDs on the copper interfaces.
Table 7-5
Status
Both LEDs off
Link amber
Link green
Activity blinking green The interface has link and is passing traffic.
Use the following table to understand bypass LEDs on the copper interfaces.
Table 7-6
Status
Off
Steady green
Steady amber
Blinking amber
The 10/100/1000 management interface is located on the front of the appliance. The following table
describes the LEDs associated with the management interface.
Table 7-7
LED
Left (link)
Firepower 7000 and 8000 Series Installation Guide
7-4
Eight-Port 1000BASE-T Copper Interfaces
Firepower 70xx Family Copper Link/Activity LEDs
Description
The interface does not have link.
The speed of the traffic on the interface is 10Mb or 100Mb.
The speed of the traffic on the interface is 1Gb.
Firepower 70xx Family Copper Bypass LEDs
Description
The interface pair is not in bypass mode or has no power.
The interface pair is ready to enter bypass mode.
The interface pair has been placed in bypass mode intentionally, or has
entered bypass mode gracefully, and is not inspecting traffic.
The interface pair has unexpectedly entered bypass mode; that is, it has failed
open.
Firepower 70xx Family Management Interface LEDs
Description
7010/20/30 Indicates whether the link is up. If the light is on, the link is
up. If the light is off, there is no link.
7050 For 10Mbps links, the link light does not illuminate. Link
status is shared with the right (activity) LED.
Chapter 7 Hardware Specifications