Cisco 7010 Installation Manual page 143

Chapter 7 Hardware Specifications
Firepower and AMP 8350 (must be 40G-capable)
•
Caution If you attempt to create a 40G interface on a device that is not 40G-capable, the 40G interface screen on
its managing Firepower Management Center web interface displays red. A 40G-capable 8250 displays
"8250-40G" on the LCD Panel and a 40G-capable 8350 displays "8350-40G" on the LCD Panel. See
Firepower 8000 Series Modules, page 4-8
Use the following table to understand link and activity LEDs of the fiber interfaces.
Table 7-52
Status
Top (activity)
Bottom (link)
Use the following table to understand bypass LED of the fiber interfaces.
Table 7-53
Status
Off
Steady green
Steady amber
Blinking amber
Use the following table to understand optical parameters of the fiber interfaces.
Table 7-54
Parameter
Optical connectors
Bit rate
Baud rate/encoding/tolerance
Optical interface
Operating distances
Transmitter wavelength
Maximum average launch power
Fiber Link/Activity LEDs
Description
The light flashes when the interface has activity. If dark, there is no activity.
The light is on when the interface has link. If dark, there is no link.
Fiber Bypass LED
Description
The interface pair does not have link and is not in bypass mode, or has no
power.
The interface pair has link and is passing traffic.
The interface has been intentionally brought down.
The interface is in bypass mode; that is, it has failed open.
40GBASE-SR4 NetMod Optical Parameters
for placement information.
40GBASE-SR4
OTP/MTP single row twelve fiber positions. Only the
outer eight fibers are used.
40.000Gbps
10.3125Gbps
64/66b encoding
+/- 100 ppm
Multimode
320 ft (100 m) for
50 µm/125 µm fiber (OM3)
Minimum distance: 2 ft (0.5 m)
40G optics are carried on eight fiber cables utilizing
MPO connectors.
840-860 nm (850 nm typical)
2.4 dBm
Firepower 7000 and 8000 Series Installation Guide
Firepower 8000 Series Devices
7-37