10
Log In to the Appliance
You can log in to the Cisco C690 appliance using one of two
interfaces: the web-based interface or the command-line
interface.
Web-Based Interface
For web browser access via the Ethernet port (see the
Step 1
"Connect to the Appliance" section on page
appliance's management interface by entering the
following URL in a web browser:
http://192.168.42.42
Log in with the following credentials:
Step 2
• Username: admin
• Password: ironport
Command-Line Interface
Access the command-line interface locally or remotely:
Step 1
• To access the CLI locally, set up a terminal to
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
on page
• To access the CLI remotely, initiate an SSH session
to the IP address 192.168.42.42.
Log in as admin with the password ironport.
Step 2
At the prompt, run the systemsetup command.
Step 3
10
"Connect to the Appliance" section
7).
7), go to the