Cisco 7010 Installation Manual page 90

Initial Setup Page: Firepower Devices
•
•
Step 2 Log in using
See the following sections for information on completing the setup:
•
•
•
•
•
•
•
•
When you are finished, click
Step 3
The device is configured according to your selections. You are logged into the web interface as the
user, which has the Administrator role.
Log out of the device.
Step 4
The device is ready to be added to its Firepower Management Center.
If you connected directly to the device using an Ethernet cable, disconnect the computer and connect the
Note
device's management interface to the management network. If you need to access the device's web
interface at any time, direct a browser on a computer on the management network to the IP address or
host name that you configured during setup.
Change Password
You must change the password for the
cannot be deleted.
This password allows the
has Configuration CLI access. Changing any user's password for the web interface also changes the
password for the CLI, and vice versa.
Cisco recommends that you use a strong password that is at least eight alphanumeric characters of mixed
case and includes at least one numeric character. Avoid using words that appear in a dictionary.
Network Settings
A device's network settings allow it to communicate on your management network. If you already
configured the device's network settings, this section of the page may be prepopulated.
Firepower 7000 and 8000 Series Installation Guide
5-6
For a device connected to a computer with an Ethernet cable, direct the browser on that computer to
the default management interface IPv4 address:
For a device where network settings are already configured, use a computer on your management
network to browse to the IP address of the device's management interface.
as the username and
admin
Change Password, page 5-6
Network Settings, page 5-6
Firepower Device LCD Panel Configuration, page 5-7
Remote Management, page 5-7
Time Settings, page 5-7
Detection Mode, page 5-8
Automatic Backups, page 5-9
End User License Agreement, page 5-9
Apply
admin
https://192.168.45.45/
as the password.
Admin123
.
account. This account has Administrator privileges and
admin
user to log into the device's web interface and its CLI; the
Chapter 5 Setting Up Firepower Managed Devices
.
admin
user
admin