Removal and Replacement
4.4 Main PCB
Removal:
1. Turn 'Off' and unplug the printer.
2. Remove the side covers (see Section 4.0).
3. Remove all Cables from their respective connectors on the Main PCB.
4. Remove the two Screws on the PCB Back Plate of the Main PCB and gently slide the Main PCB out
of the printer.
Main PCB
PCB Back
Plate
Screws
Installation:
1. Position the Main PCB in the printer. Secure using the two Screws on the PCB Back Plate.
2. Re-connect all cables to their respective connectors on the Main PCB.
3. Re-install the side covers (see Section 4.0).
4-10