Datamax ?-class series Maintenance Manual page 44

Displayed Message
!
!
HPPECZF!
!
!
!
IFBE!OFFET!DMFBOJOH!
!
!
!
IPTU!DIBOHFT!QFOEJOH!
!
!
!
MPX!WPMUBHF!
!
!
SUD!SBN!GBJMVSF!
!
!
!
UFNQFSBUVSF!QBVTF!
Troubleshooting
Warning Messages
Description
Power has been removed
and shutdown is in
progress.
The scheduled printhead
cleaning distance has been
reached.
The host has pending
configuration changes that
will not take effect until a
'host reset command' is
issued.
The 24 VDC line has
dipped below the threshold
value.
The printer was unable to
save settings in permanent
memory.
A high printhead
temperature has been
detected.
3-4
Possible Solution(s)
The printer power switch was turned
'Off', the line fuse has blown, or the AC
line voltage has been lost.
Clean the printhead. See Section 2.1.2 or
2.1.3 for details.
To save the changes, send a host reset
command (in DPL). To discard the
changes perform a soft reset; see Section
2.10 for details.
Possible low or fluctuating line voltage
level. If this condition persists, try moving
the printer to another outlet circuit. Other
possible causes include a faulty power
supply, main logic board, or printhead.
If the condition persists, possible faulty
main logic board; see Section 4.4.
Allow the printhead time to cool before
continuing to print.