Overview This document describes the contents, installation, and use of the Present Sensor option for the H-Class printer. After verifying the contents of the kit, follow the steps below to install and begin using the option. A maintenance procedure is also included, so keep this documentation for future reference. For your safety and to avoid equipment damage, always turn ‘Off’...
Page 4
C) Raise the Access Cover and remove your Access Cover media from the printer. Tear Plate D) Loosen and remove the Thumbscrew and then remove the Tear Plate. (Alternately, if equipped with an Arc Plate, Cutter, or Peel and Thumbscrew Present option, remove that device.) Step 2: Installing the Present Sensor A) Carefully press the Present Sensor Assembly...
Page 5
Step 3: Using the Option During operation, labels will be dispensed “on-demand” – that is, subsequent printing will occur only after a previously printed label has been removed from the printer. As a reminder, “REMOVE LABEL” will be displayed to prompt you when a label awaits removal. Begin using the option as follows: A) Load media and close the Access Cover (see the Operator’s Manual for details).
Step 4: Configuring the Printer While the Present Sensor is a plug and play device, this step may be necessary if the printer’s default configuration has been changed. Follow the steps below to configure the printer: Note: In the following procedure, consult the Operator’s Manual for detailed front panel instructions. A) Press the MENU Button on the printer’s front panel.
Page 7
Maintaining the Option To ensure trouble free operation, the Present Sensor should be cleaned after every 100,000 inches (254,000 cm) of media use. (To easily track label usage, go to SYSTEM SETTINGS MEDIA COUNTERS in the printer’s menu system.) Clean the assembly as follows: 1.