Downloading Firmware And Fonts - Datamax ?-class series Maintenance Manual

2.8 Downloading Firmware and Fonts

The operating programs and fonts for the printer are stored in Flash memory on the Main PCB. When
program updates and/or new features are added, they can be downloaded to the printer as follows:
1. Identify the new version of firmware for your model of printer from the Datamax website at
www.datamaxcorp.com
2. Download the firmware onto your computer's hard drive or a floppy disk. Ensure that the printer is
connected to the host via the parallel port, and that the printer is powered 'On.' Then, depending upon
your printer model, use the DOS copy command:
copy filename.dlf lpt1/b
copy filename.zs lpt1/b
Note: Other programs (e.g., hyper-terminal and certain Windows
download this file.
The light will flash during the download.
READY
3. Following a successful download, the
'cold reset.' The previous printer setup will not be affected unless substantial firmware data structure
changes have occurred. Print a Database Configuration Label to verify your new firmware version
(see the Operator's Manual for details).
Note: If the ERROR
perform a 'warm reset' (both the
original firmware will remain operational. Should the printer fail to reset, toggle the power 'Off' and 'On.'
Try re-sending the file to the printer. If the failure continues, however, check the following as possible causes:
• An invalid or corrupted file is being downloaded: Ensure that the file being downloaded is correct and applicable
for your printer model.
• There may be a communications error: Check the cable connection between the host and printer and ensure
that a quality, shielded cable is used.
• There may be Flash memory problem: Replace the Main PCB (see Section 4.4).
Adjustments and Maintenance
(Non-Display model firmware is .dlf extension)
(Display-Equipped model firmware is .zs extension)
STOP
Light illuminates then the download was unsuccessful. In this case, the printer will
and
READY STOP
2-24
®
Driver programs) may also be used to
Light will illuminate then the printer will perform a
lights will be on during power-up initialization) and the