Resetting The Printer; Non-Display Models; Display-Equipped Models - Datamax ?-class series Maintenance Manual

2.9 Resetting the Printer

To reset the printer proceed according to the model.
2.9.1

Non-Display Models

Turn 'Off' the printer. Press and hold all three buttons and turn 'On' the printer. Continue to depress the
buttons down until the
'Factory Defaults.' See the Operator's Manual for a listing of these values.
2.9.2

Display-Equipped Models

Depending upon the method used, there are three reset levels possible. Each is described below:
Soft Reset
To reset the printer and clear any temporary host settings:
With the printer 'On', press and hold the CANCEL Key for approximately four seconds.
Level One Reset
To return the printer to the factory default settings or, if saved, to restore the Factory Setting File:
Note: This has the same effect as the 'Set Factory Defaults' menu item. (See the Operator's Manual for details.)
Turn 'Off' the printer.
Press and hold the PAUSE and CANCEL Keys while turning 'On' the printer; continue to depress the
keys until the 'READY' message appears.
Level Two Reset
To return the printer to the factory default settings, and clear all the calibration and adjustment
parameters:
Turn 'Off' the printer.
Press and hold the PAUSE, FEED, and CANCEL Keys while turning 'On' the printer; continue to
depress the keys until the 'READY' message appears.
Note: After executing a Level 2 Reset, calibration must be performed; see Section 2.2. For a listing of the
factory default values, see the Operator's Manual.
Adjustments and Maintenance
light turns off (about 17 seconds). The printer's settings are now at
STOP
2-25